, 2005, 2006). For confocal analysis, biofilms were grown under similar conditions for Selleckchem BI-6727 24 and 72 h, and were treated with either Live/Dead BacLight fluorescent dye (Invitrogen, CA) or concanavalin A lectin conjugated with Alexa Fluor 488 and SYTO 59 (Invitrogen) before optical dissections using an Olympus Fluoview BX61 confocal laser scanning microscope (Olympus). Simulated xyz three-dimensional images were generated using

slidebook 5.0 (Olympus). To measure the extracellular glucose polymers in biofilms, a phenol-sulfuric acid assay was used with known concentrations of glucose as the standards (Mukasa et al., 1985; Kumada et al., 1987; Ausubel et al., 1992; Werning et al., 2008). Briefly, 3-day biofilms

were grown in BMGS on glass slides in 50-mL tubes PD98059 mouse as described elsewhere (Phan et al., 2000; Wen et al., 2010a, b). Following brief sonication, bacterial cells were removed by centrifugation (4000 g, 4 °C for 15 min). Exopolysaccharide in the supernatant fluid was precipitated with two volumes of ethanol overnight at −20 °C, and was washed twice with 80% ethanol before the OD490 nm was measured (Ausubel et al., 1992; Werning et al., 2008). To evaluate the ability of S. mutans strains to withstand oxidative stress, 3-day biofilms were prepared using glass slides as described above, and hydrogen peroxide challenge assays were carried out as detailed elsewhere (Wen & Burne, 2004, 2006, 2010a, b). For transcriptional profiling, S. mutans strains were grown in 50 mL of BHI broth, and following brief treatment with RNAProtect as suggested by the manufacturer, total RNAs were isolated using hot phenol as described previously (Wen & Burne, 2004; Wen

et al., 2005, 2006, 2010a). To remove all DNA, RNA preps were treated with DNaseI (Ambion Inc.) and retrieved with the RNeasy purification kit (Qiagen Inc.). Array analysis was performed using the whole-genome S. mutans microarrays www.selleck.co.jp/products/Docetaxel(Taxotere).html that were obtained from The J. Craig Venter Institute (JCVI, http://pfgrc.jcvi.org) by following the protocols recommended by JCVI as described elsewhere (Abranches et al., 2006; Wen et al., 2006, 2010a). Array data were normalized with the TIGR Microarray Data Analysis System (http://www.jcvi.org/software) and further analyzed using brb array tools 3.01 (developed by Dr Richard Simon and Amy Peng Lam, National Cancer Institute, MD, http://linus.nci.nih.gov/BRB-ArrayTools.html) as described elsewhere (Abranches et al., 2006; Wen et al., 2006, 2010a). Genes that were differentially expressed by a minimal ratio of 1.5-fold and at a statistical significance level of P<0.001 were then identified. For RealTime-PCR analysis, cDNA was synthesized with 1 μg of total RNA using the iScript cDNA synthesis kit (Bio-Rad) by following the procedures recommended by the manufacturer.