[27] used carbon-rich Saudi Arabian fly ash to produce CNTs. These tubes were also synthesized through a CVD process, but pre-treatment of the ash to remove

unburned carbon was required in order to use the ash as a catalyst. Reports on the effectiveness of fly ash as a catalyst or template in the synthesis of CNFs are limited [27, 28, 36]. Moreover, fly ash is either considered as a support for other more active metallic catalyst particles [28, 36] or used after extensive synthetic treatment [27]. On the other hand, no work has been done using the South #selleck chemicals llc randurls[1|1|,|CHEM1|]# African coal fly ash to make CNFs. This article reports a simple, direct route for the synthesis of CNFs from South African coal fly ash and acetylene at varying temperatures. Here no pre-treatments or additions of expensive catalysts were required, as the fly ash was used as received.

Methods Synthesis Waste South African coal fly ash was obtained from the Electricity Supply Commission (ESCOM) Research and Innovation Centre (Rosherville, South Africa) and was used without any chemical pre-treatments or thermal modifications. Carbon deposition was achieved by the catalytic chemical Luminespib vapour deposition method (CCVD) of acetylene over the waste coal fly ash. In these reactions, the coal fly ash was the catalyst, acetylene the carbon source and hydrogen the carrier gas, to create an optimal reaction environment [37–39]. In each synthesis run, 500 mg of as-received fly ash was uniformly spread in a small quartz boat and placed in the centre of a horizontal furnace. The coal fly ash was then heated at 10°C/min in H2 at 100 ml/min to temperatures

between 400°C and 700°C in 100°C increments, where upon acetylene gas was introduced into the reaction zone at 100 ml/min for 30 min. After 30 min of reaction time, the flow of acetylene was terminated and the reactor was cooled under H2 to ambient temperature. The resultant carbonaceous material was then harvested for characterization. Characterization To identify the metals and their amounts (Table 1) found in the coal fly ash, X-ray fluorescence (XRF) was employed. The morphologies and particle sizes of the as-received and acetylene-treated fly ash were characterized by transmission electron microscopy (TEM) using a FEI Tecnai G2 Spirit electron microscope (FEI Co., RAS p21 protein activator 1 Hillsboro, OR, USA) at an accelerating voltage of 120 kV. Energy-dispersive X-ray spectroscopy (EDS) was used to identify the catalyst/s present in the acetylene-treated fly ash. X-ray diffraction (XRD) and Mössbauer spectroscopy were also used to confirm the catalyst responsible for CNF formation. XRD measurements were carried out with the help of a Bruker D2 phaser (Bruker AXS, Karlsruhe, Germany) in Bragg-Brenton geometry with a Lynexe detector using Cu-Kα radiation at 30 kV and 10 mA. The samples were scanned from 10° to 90° theta (θ).