Thus, Equation (1) can be rewritten as (3) Applying Laplace transform, it yields (4) where a function with ‘∧’ denotes Laplace-transformed function in s domain. Performing inverse Laplace transform, the viscoelastic equation of AFM-based indentation becomes (5) where Solution to AFM-based indentation equation It is observed from Figure 3 that the initial indentation force at t = 0 was measured to be 104.21 nN, then the force started to decrease and then remained constant at 38 nN after ~5,000 ms. The force decrease shown as red asterisks in Figure 3b fits qualatitatively well with the exponential function of Equation (5). E 1, E 2, and

η, corresponding to the mechanical property parameters in Figure 2(a), selleck chemicals can then be determined by fitting Equation (5) with the experimental data. From the indentation data, D0 is obtained to be 78.457 nm. The pull-off force, 2πwR, calculated by averaging the

pull-off forces of multiple indentations on the sample, is 16 nN. In comparison with the radius of the AFM tip, the surface of the sample can be treated as SC79 in vivo a flat plane. Hence, the nominal radius R = R tip  = 12 nm. By invoking the force values at t = 0, t = ∞, and any intermediate point into Equation (5), the elasticity and viscosity components can be determined to be E 1  = 32.0 MPa, E 2  = 21.3 MPa, and η = 12.4 GPa ms. The coefficient of determination R 2 of the viscoelastic equation and the experimental data is ~0.9639. Since the stress relaxation process is PF-6463922 achieved by modeling a combination of the cantilever and the sample, the viscoelasticity of the sample can be obtained by subtracting the component of the cantilever from the results. The cantilever, acting as a spring, is in series with the sample, represented by a standard solid model. The schematic of the series organization

is shown in Figure 2(b). Thus the component of E 1 comprises of E 1s representing the elastic part from the sample and E 1c representing GPCR & G Protein inhibitor the elastic part from the cantilever. To clarify the sources of the components in the modified standard solid model, E 2, v 2, and η in Figure 2(a) are now respectively denoted by E 2s , v 2s , and η s in Figure 2(b), where the subscript ‘s’ denotes the sample. At the onset of indentation, only the spring with elastic modulus of E 1 takes the instantaneous step load; therefore, the elastic modulus of E 1s can be determined from the experimental data of zero-duration indentation. Applying the DMT model [46] with the force-displacement relationship of the cantilever, (6) we can obtain the elastic equation of AFM-based indentation (7) where k is the spring constant of the cantilever, which is 5 nN/nm based on Sader’s method [47] to calibrate k, δ cantilever is the cantilever deflection, and δ is recorded directly as the Z-piezo displacement by AFM.